Table of Contents
Advertisement
Serial Protocol Table Entries
Address: The panel address from 1 to 16. This address must be unique for
panels sharing the same Control module's serial port.
Panels are normally shipped with a panel address of "01." This number is
referred to as the "Device Number" on the IP configuration page and "ID"
within the L-S or LCD Panels MENU system.
Input Set: Input and output set types should be CPESXTND for Device
type CPES-SER.
In Panel: This column is not used for L-S or LCD panels.
Out Set: Input and output set types should be CPESXTND for Device type
CPES-SER. If the entry is an actual CP Output Set, then the control panel
will be able to control all the outputs listed in that Set. Depending on the
contents of the set, this would allow for full-matrix or multi-bus control.
Out Panel: This column is not used for L-S or LCD panels.
Level Set: Follows the same rules as L/S/LCD panels.
Override Set: Follows the same rules as L/S/LCD panels.
Sequence: Follows the same rules as L/S/LCD panels.
Special Entries Needed to Upgrade Serial Panels
Special IP settings are required to download new or upgrade software to
panels that are normally operated in Serial mode. IP addresses are set using
the Web page or through NetConfig. See
IP Configuration Procedure
for more
information.
All Systems
Control Panel Sets
The Switcher inputs and outputs for the L-S and LCD panels are specified
by creating a CP Level Set of type CP-3800 type level set for CPESXTND
device types. These sets are assigned to each panel using the MPK Devices
table.
With the L-S and LCD panels, the CP Level Set does establish the order in
which levels are displayed on the panel
JUPITER L-S and LCD Series Control Panel Instruction Manual
77
Advertisement
Table of Contents
