Protecting Or Locking A Destination - GRASS VALLEY JUPITER L - V2.1.0 Instruction Manual

Protecting or Locking a Destination

JUPITER L-S and LCD Series Control Panel Instruction Manual125
Note Destinations that have been defined in the panel's CP Output set using the
Jupiter Configuration Editor cannot be changed using the panel itself. If such
an attempt is made, the panel will display the following message: "????"
1. Press . The D1- D16 windows will display pages of Destinations.
Dest
2. Press the soft button next to the desired button location. Use the
arrow buttons if necessary to scroll through the pages of button
locations.
3. Select the desired Destination by pressing a category (For example,
"VTR") and unit number combination. The name of the Destination,
and the category/number, will appear in the window.
4. Press . The Destination will appear in the selected location.
Take
5. To assign more Destinations, repeat
6. When finished, press the
The window(s) just programmed will indicate the Destination name in
yellow and the current Source for that Destination in green.
1. Confirm that the desired Destination(s) are selected. In Single
Destination mode the Destination appears in the D15 window. In
Multiple Destination mode soft buttons for the selected Destinations
are illuminated on the Destination page displays.
Note Only multiple Destinations located on the same page can be protected or
locked simultaneously. To protect or lock multiple Destinations on different
pages, access each page individually to select the Destinations.
2. Choose whether to protect or lock the Destination(s):
• To protect, press
amber, indicating a protect operation in progress.
• To lock, press
Protect/Lock
indicating a lock operation in progress.
The button will illuminate green.
Take
Step 2
and buttons to exit the mode.
Clear Dest
once. The button will then illuminate
Protect/Lock
twice. The button will then illuminate red,
LD16 Control Panel
Up/Down
through Step 4.