Selecting The Destination From The Level Menu; Selecting The Source From The Level Or The Multiple Destination Menus - GRASS VALLEY JUPITER L - V2.1.0 Instruction Manual

Selecting the Destination from the Level Menu

Selecting the Source from the Level or the Multiple Destination Menus

JUPITER L-S and LCD Series Control Panel Instruction Manual177
Figure 96. LCD48 - Select Destination Mode
Entry Buttons
4. Select a Category from the Category side or right-hand side. The Entries
that are assigned to the Category will then appear on the left -hand side.
5. Select a Destination from the Destination entries on the left hand side of
the panel.
A Destination can be selected from the Level menu since there is a "shortcut
key.
A Source can be selected from the Level or the Multiple Destination menus.
There are two methods of selecting a Source, Direct Entry and Category
Entry. Each of these methods will be explained below. Both of these Instruc-
tion steps assume the green
pressed. The LCD16 is different from the LCD48 because the LCD48 dis-
plays both the Direct Entry (on the Left half) and the Category Entry (on the
Right half) of the panel. The LCD16 requires the use of
to switch between the direct entry and category entry modes.
Selecting the Source using the Direct Entry Method
Follow these steps to select a Source using the Direct Entry method:
1. Scroll through the available Sources using the Scroll wheel. The Sources
will change.
2. Select the Source by pressing the destination button. The selected
Source is now the "current destination." The panel will then
immediately revert back to the previous mode. For example, the Level
mode.
Category Buttons
button in the Level mode has been
Source
Basic Panel Operations
button
Select Source