L-S Series Panel Operation
Introduction
Section Contents
Color Bitmap Displays
Destination/Status
JUPITER L-S and LCD Series Control Panel Instruction Manual95
This section assumes panels have been properly installed and configured
for operation at your facility. Buttons are configured to control Sources and
Destinations using the Jupiter CP Input and Output sets, Levels are deter-
mined with CP Level sets, and these sets are assigned to the panel using the
MPK Devices table (see Section 4-Jupiter System Configuration).
LD4 Control Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
LD16 Control Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S100 Control Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
SXY Control Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Three different types of L-S panel color displays exist. Different panel types
are equipped with different display types and numbers. The S25 and S50
panels do not have color bitmap displays.
Typical display information is indicated below. Different information is dis-
played in some modes, however. For example, pressing the
brings up screens allowing menu navigation and setting selections.
Typically reports the names of the currently controlled Destination and the
Source currently routed to that Destination. The status display may also
show the Source or Destination selected for the next action.
6
Section
page 100
page 110
page 119
page 128
page 132
page 135
button
Menu