Table of Contents
Advertisement
Getting Started
Configure Initial Settings in the Control Screen
Configure Initial Settings in the Control Screen
The minimum initial settings needed to get started with the panel are described below.
On the ATP-2000 control screen (web page), configure the following items:
•
Step 1: Network Settings
•
Step 2: GV Orbit Server Settings
•
Step 3: Panel Manager Settings
Step 1: Network Settings
1 In the default panel configuration, DHCP is enabled on the panel.
In this case, no further network settings action is required and proceed to
Orbit Server
However,
if other, particular network settings are required then do the following:
2 Configure the unit's network settings for the following, as required:
• DHCP or static IP address enabled; and
• for the static IP address case:
3 Click Apply to apply any network settings changes.
Step 2: GV Orbit Server Settings
1 Configure GV Orbit server settings:
• GVOP Domain - GV Orchestration Protocol (GVOP) Domain number.
• GV Server IP - IP address of the GV Orbit server in the system.
• Panel Id - 'Panel Id' for the ATP-2000 unit in the GV Orbit system. This is a RollCall
• Panel Name - Enter a unique and meaningful 'Panel Name' for the ATP-2000 unit in
• Optionally, enter:
2 Click Apply to apply the server settings.
18
Settings.
• IP Address.
• Subnet mask.
• Default gateway IP address.
Note: An ATP-2000 panel is discoverable by the GV Orbit Client, if multicast
network traffic is enabled and is visible to both the Client and the
panel. See ATP-2000 Software Release Notes for IP port information.
(See
Related
Documentation, on page iii.)
address (for example E000:01:00) which must be unique in a system.
the system (for example, 'Eng GV Panel').
Note: Panel Name will identify the panel, for example, in the Network
window of GV Orbit Client.
• Location - A location for the panel (for example, 'Studio A'); and
• Notes - Any operational, informative notes to accompany the panel.
Step 2: GV
Advertisement
Chapters
Table of Contents
