GRASS VALLEY JUPITER L - V2.1.0 Instruction Manual page 82

Section 5 — Connecting the L-S, LCD Panel
82
Follow these steps to change the Connection Type setting using the S25 or
the S50 panel's menu:
1. Press the
Destination
button in the lower-left corner at the same time, for
Destination
approximately three (3) seconds
The
Serial Mode Cancel
50 (S50), should light up red.
The current
Panel ID
1 and16. The button will not light up amber if the range is greater than
16.
Figure 47. S25 Front Panel
Panel ID Button Serial Mode Cancel Button
2. Select one of the Panel ID buttons (1-16) to assign the Panel ID if you
want to change the panel's ID. The selected button will then show high
tally amber.
The
Serial Mode Accept
corner) will then blink green
Figure 48. Serial Mode Accept Button
3. Press the
Serial Mode Accept
The Panel will then reboot and apply the changed settings.
JUPITER L-S and LCD Series Control Panel Instruction Manual
button that is in the upper-right corner and the
(Figure 47).
button, button number 25 (S25), or button number
button will be high tally amber if the ID is between
Press and Hold these two Buttons
button (the
Destination
(Figure 48).
Serial Mode Accept Button
button.
button in the lower-right