Qos Map Cos-Mutation - Dell 8 Command Reference Manual

qos map cos-mutation

Creates a QoS map for performing CoS-to-CoS mutation.
Synopsis qos map cos-mutation name cos0 cos1 cos2 cos3 cos4 cos5 cos6 cos7
no qos map cos-mutation name
Operands name
cos0
cos1
cos2
cos3
cos4
cos5
cos6
cos7
Defaults There are no CoS-to-CoS mutation QoS maps defined.
Command Global configuration mode
Modes
Description Use this command to create a QoS map for performing CoS-to-CoS Mutation. A CoS-to-CoS
mutation takes an inbound CoS value and maps it to an outbound CoS value. The inbound CoS
value is the user priority after any interface ingress QoS trust and Interface default CoS policy have
been applied. The outbound CoS value is used in selecting Traffic Class and egress packet
marking. The default is no CoS-to-CoS Mutation QoS maps defined. Use the no qos map
cos-mutation name command to delete the named CoS-to-CoS mutation QoS map. A QoS map can
only be deleted if it is not bound to any interface.
Usage There are no usage guidelines for this command.
Guidelines
Examples To create a CoS-to-CoS mutation QoS map to swap CoS 4 and CoS 5 and apply it on an interface,
for example inbound CoS 4 is mapped to outbound CoS 5 and inbound CoS 5 is mapped to
outbound CoS 4; all other CoS values go through unchanged:
To delete a CoS-to-CoS mutation QoS map:
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
Specifies a unique name across all CoS-to-CoS mutation QoS maps defined
within the system. If the named CoS-to-CoS mutation QoS map does not exist,
then it is created. If the named CoS-to-CoS mutation QoS map already exists
then, it is updated and new mapping is automatically propagated to all
interfaces bound to the QoS map.
Sets the outbound CoS value for all packets with inbound CoS 0.
Sets the outbound CoS value for all packets with inbound CoS 1.
Sets the outbound CoS value for all packets with inbound CoS 2
Sets the outbound CoS value for all packets with inbound CoS 3.
Sets the outbound CoS value for all packets with inbound CoS 4.
Sets the outbound CoS value for all packets with inbound CoS 5.
Sets the outbound CoS value for all packets with inbound CoS 6.
Sets the outbound CoS value for all packets with inbound CoS 7.
switch(config)#qos map cos-mutation test 0 1 2 3 5 4 6 7
switch(config)#interface intengigabitethernet 0/1
switch(conf-if-te-0/1)#qos cos-mutation test
switch(config)#no qos map cos-mutation test
qos map cos-mutation
16
247