Qos Cos-Traffic-Class - Dell 8 Command Reference Manual

16

qos cos-traffic-class

qos cos-traffic-class
Applies a CoS-to-Traffic Class QoS map on an interface.
Synopsis qos cos-traffic-class name
no qos cos-traffic-class
Operands name
Defaults There is no explicit CoS-to-Traffic Class QoS map applied; the implicit behavior is to match the IEEE
802.1Q recommendations for systems supporting eight Traffic Classes.
Command Interface configuration mode
Modes
Description Use this command to apply a CoS-to-Traffic Class QoS map to an interface. Use the no qos
cos-traffic-class command to remove the CoS-to-Traffic Class mapping.
Usage This command is not available when the interface is in the CEE Provisioning mode.
Guidelines
Examples To apply a CoS-to-Traffic Class QoS map to an interface:
See Also qos map cos-traffic-class, qos trust, qos cos-mutation, show qos maps
246
Specifies the name of a previously created CoS-to-Traffic Class QoS map. Only
one CoS-to-Traffic Class QoS map can exist at a time. An existing
CoS-to-Traffic Class QoS map must be removed before a new one can be
applied.
switch(conf-if-te-0/1)#qos cos-traffic-class test
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01