Hello - Dell 8 Command Reference Manual

hello

Sets the Hello transmit interval.
Synopsis hello seconds
no hello
Operands seconds
Defaults The default is 30 seconds.
Command Protocol LLDP configuration mode
Modes
Description Use this command to set the interval between LLDP hello messages. Use the no hello command to
return to the default setting.
Usage There are no usage guidelines for this command.
Guidelines
Examples To set the time interval to 10 seconds between the transmissions:
See Also none
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
Sets the Hello transmit interval. The range of valid values is 4-180 seconds.
switch#configure terminal
switch (config) #protocol lldp
switch(conf-lldp)#hello 10
6
hello
105