Lacp System-Priority - Dell 8 Command Reference Manual

lacp system-priority

Sets the Link Aggregation Control Protocol (LACP) system priority.
Synopsis lacp system-priority value
no lacp system-priority
Operands value
Defaults The default system-priority value is 32768.
Command Global configuration mode
Modes
Description Use this command to set the system priority of a local system. This determines which system is
responsible for resolving conflicts in the choice of aggregation groups. Use the no lacp
system-priority command to reset the system priority to the default value.
Note Lower numerical values have higher priorities.
Usage There are no usage guidelines for this command.
Guidelines
Examples To set the LACP system-priority to 68:
To clear the configured LACP system-priority:
See Also none
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
Specifies the value of the LACP system priority. The range of valid values is
1-65535.
switch(config)#lacp system-priority 68
switch(config)#no lacp system-priority
lacp system-priority
127
7