Debug Lacp - Dell 8 Command Reference Manual

debug lacp

Enables debugging for the Link Aggregation Control Protocol (LACP).
Synopsis debug lacp {all | cli | event | nsm | pdu {rx {all | interface {in | ex}tengigabitethernet slot/port} | tx
{all | interface {in | ex}tengigabitethernet slot/port}}| sync | timer | trace level number}
no debug lacp {all | cli | event | nsm | pdu {rx {all | interface {in | ex}tengigabitethernet slot/port}
| tx {all | interface {in | ex}tengigabitethernet slot/port}}| sync | timer | trace level number}
Operands all
cli
event
nsm
pdu
sync
timer
trace level number
Defaults By default, debugging is not turned on.
Command Privileged EXEC mode
Modes
Description Use this command to enable debugging for Link Aggregation Control Protocol (LACP). Use the no
debug command to disable debugging.
Usage To display debug outputs on a specific cmsh session, use the terminal monitor command.
Guidelines
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
Turns on all debugging.
Turns on command line interface debugging.
Turns on event debugging.
Turns on Network Services Module (NSM) debugging.
Turns on PDU debugging.
rx all Turns on debugging for received LACP packets on all interfaces.
rx interface Turns on debugging for received LACP packets on the specified
interface.
interface tengigabitethernet
Specifies the 10 Gbps Ethernet interface.
slot Specifies the slot number.
port Specifies the port number.
tx all Turns on debugging for transmitted LACP packets on all interfaces.
tx interface Turns on debugging for transmitted LACP packets on the specified interface.
interface tengigabitethernet
Specifies the 10 Gbps Ethernet interface.
slot Specifies the slot number.
port Specifies the port number.
Turns on debugging for LACP sync transitions.
Turns on debugging for LACP timers.
Specifies the trace level number. The range of valid values is 1-7.
7
debug lacp
125