Mac Access-Group - Dell 8 Command Reference Manual

mac access-group

Applies rules specified in a MAC ACL to traffic entering an interface.
Synopsis mac access-group name [in]
no mac access-group name
Operands name
in
Default There are no access lists applied to the interface.
Command Interface configuration mode
Modes
Description Use this command to apply a MAC ACL to a Layer 2 or a VLAN interface. You create the MAC ACL by
using the mac access-list global configuration command. Use the no mac access-group command
to remove the MAC ACL from the interface.
Usage You can assign one MAC ACL (standard or extended) to an interface.
Guidelines
When a packet is received on an interface with a MAC ACL applied, the switch checks the rules in
the ACL. If any of the rules match, the switch permits or drops the packet, according to the rule. If
the specified ACL does not exist, the switch permits all the packets.
Example To apply a MAC ACL named macacl2 on an interface:
To remove a MAC ACL named macacl2 from an interface:
See Also mac access-list standard, mac access-list extended, show access-lists
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
Specifies the name of the standard or extended MAC access list.
Specifies to filter inbound packets only.
switch(conf-if)#mac access-group macacl2 in
switch(conf-if)#no mac access-group macacl2
10
mac access-group
147