Chapter 11 Spanning Tree Protocol Commands; Bridge-Priority - Dell 8 Command Reference Manual

Spanning Tree Protocol Commands

bridge-priority

Specifies the priority of the bridge.
Synopsis bridge-priority priority
no bridge-priority
Operands priority
Defaults The default priority is 32678.
Command Protocol Spanning Tree mode
Modes
Description Use this command to set the bridge priority for the common instance. Using a lower priority value
indicates that the bridge might become root. Use the no bridge-priority command to return to the
default settings.
Usage This command must be used to specify the priority of the bridge. The priority values can be set only
Guidelines in increments of 4096.
Examples To specify the bridge priority:
see Also protocol spanning-tree
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
Specifies the bridge priority. The range of valid values is 0-61440.
switch#configure terminal
switch(config)#protocol spanning-tree stp
switch(conf-stp)#bridge-priority 8192
switch#configure terminal
switch(config)#protocol spanning-tree rstp
switch(conf-rstp)#bridge-priority 8192
switch#configure terminal
switch(config)#protocol spanning-tree mstp
switch(conf-mstp)#bridge-priority 8192
Chapter
11
157