Qos Trust Cos - Dell 8 Command Reference Manual

16

qos trust cos

qos trust cos
Specifies the interface QoS trust mode for incoming traffic.
Synopsis qos trust cos
no qos trust
Operands none
Defaults The QoS trust CoS mode set to the untrusted state.
Command Interface configuration mode
Modes
Description Use this command to specify the interface ingress QoS trust mode, which controls user priority
mapping of incoming traffic. The untrusted mode overrides all incoming priority markings with the
Interface Default CoS. The CoS mode sets the user priority based on the incoming CoS value, if the
incoming packet is not priority tagged, then fallback is to the Interface Default CoS value. Use the
no qos trust command to return to the default.
Usage When a CEE map is applied on an interface, the qos trust command is not allowed. The CEE map
Guidelines always puts the interface in the CoS trust mode. This command is not applicable for port-channel
interfaces.
Examples To set the interface QoS to the trust mode:
To return the interface QoS to the default value or to the untrusted state:
When a CEE map is applied, the switch does not allow the qos trust cos command and displays the
following error:
See Also qos cos, show qos
256
switch(conf-if-te-0/1)#qos trust cos
switch(conf-if-te-0/1)#no qos trust
switch(conf-if-te-0/1)#cee demo
switch(conf-if-te-0/1)#qos trust cos
% Error: QoS is not in non-CEE Provisioning mode
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01