Spanning-Tree Priority - Dell 8 Command Reference Manual

11

spanning-tree priority

spanning-tree priority
Changes an interface's spanning-tree port priority.
Synopsis spanning-tree priority priority
no spanning-tree priority priority
Operands priority
Defaults The default value is 128.
Command Interface configuration mode
Modes
Description Use this command to change an interface's spanning-tree port priority. Use the no spanning-tree
priority command to return to the default setting.
Usage There are no usage guidelines for this command.
Guidelines
Examples To configure the port priority to 16:
See Also spanning-tree cost, show spanning-tree
192
Specifies the interface priority for the spanning tree. The range of valid values
is 0-240. Port priority is in increments of 16.
switch(conf-if-te-0/1)#spanning-tree priority 16
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01