Debug Lldp Packet - Dell 8 Command Reference Manual

debug lldp packet

Enables debugging for Link Layer Discovery Protocol (LLDP).
Synopsis debug lldp packet {all | interface {in | ex}tengigabitethernet slot/port} [both | detail [both | rx | tx]
| rx | tx]
no debug lldp packet {all | interface {in | ex}tengigabitethernet slot/port}
Operands all
interface
Defaults By default, debugging is not turned on.
Command Privileged EXEC mode
Modes
Description Use this command to enable debugging for Link Layer Discovery Protocol (LLDP). Use the no debug
lldp packet command to disable debugging.
Usage To display debugging outputs on a particular cmsh session, use the terminal monitor command.
Guidelines
To enable debugging of LLDP for both received and transmitted packets on 10 Gbps Ethernet
Examples
interface 0/1:
See Also show debug lldp
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
Turns on LLDP packet debugging on all interfaces.
Use this keyword to specify any of the following interfaces:
extengigabitethernet
Specifies a valid external 10 Gbps Ethernet interface.
slot Specifies a valid slot number.
port Specifies a valid port number.
intengigabitethernet
Specifies a valid internal 10 Gbps Ethernet interface.
slot Specifies a valid slot number.
port Specifies a valid port number.
both Turns on debugging for both transmit and receive packets.
detail Turns on debugging with detailed information.
rx Turns on debugging for only received LLDP packets.
tx Turns on debugging for only transmitted LLDP packets.
switch#debug lldp packet interface intengigabitethernet 0/1 both
switch#show debug lldp
LLDP debugging status:
Interface te0/1 : Transmit Receive
debug lldp packet
103
6