Switchport Trunk - Dell 8 Command Reference Manual

switchport trunk

Adds or removes tagged VLANs on a Layer 2 interface.
Synopsis switchport trunk allowed vlan {add vlan_id | all | except vlan_id | none | remove vlan_id}
no switchport trunk
Operands allowed vlan
add vlan_id
all
except vlan_id
none
remove vlan_id
Defaults There are no default configurations for this command.
Command Interface configuration mode
Modes
Description Use this command to add or remove tagged VLANs on a Layer 2 interface.
Usage There are no usage guidelines for this command.
Guidelines
Examples To set the tagged VLAN on an interface to 100:
To remove the tagged VLAN 100 from the interface:
See Also show vlan brief, show interface switchport, switchport mode, switchport trunk
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
Sets the VLANs that will transmit and receive through the Layer 2 interface.
Adds a VLAN to transmit and receive through the Layer2 interface. The range
of valid values is 2-3583.
Allows all VLANs to transmit and receive through the Layer 2 interface.
Allows all VLANs except the VLAN ID to transmit and receive through the Layer
2 interface. The range of valid values is 2-3583.
Allows no VLANs to transmit and receive through the Layer 2 interface.
Removes a VLAN that transmits and receives through the Layer 2 interface.
The range of valid values is 2-3583.
switch(conf-if-te-0/19)#switchport truck allowed vlan add 100
switch(conf-if-te-0/19)#switchport truck allowed vlan remove 100
3
switchport trunk
55