9
fcoeport
fcoeport
Applies the FCoE map to an interface.
Synopsis
fcoeport
Operands
none
Description
Use this command to apply the FCoE map to an interface. You must be in interface mode for a
selected interface.
Defaults
There are no default configurations for this command.
Command
Interface configuration mode
Modes
User Guidelines
If the interface is configured as fcoeport, the fcoeport configuration will take precedence over the
switchport mode. If the switchport mode is configured as access or trunk it will be ignored.
Example
Enter interface mode, then apply the FCoE map.
switch(config)#interface extengigabitethernet 0/20
switch(conf-if-ext-0/20)#fcoeport
See Also
fcoe-map
138
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01