Switchport Mode - Dell 8 Command Reference Manual

3

switchport mode

switchport mode
Sets the mode of the Layer 2 interface.
Synopsis switchport mode {access | trunk | converged}
Operands access
trunk
converged
Defaults There are no defaults for this command.
Command Interface configuration mode
Modes
Description Use this command to set the mode of the Layer 2 interface.
Usage With this command, the interface can be set to access mode for non-FCoE traffic, or converged
Guidelines mode for FCoE/non-FCoE traffic. However, the preferred way of configuring an interface for FCoE is
with the command fcoeport with the port configured in access mode.
Examples To set the mode of the interface to access:
To set the mode of the interface to trunk:
To set the mode of the interface to converged:
See Also show vlan brief, show interface switchport, switchport trunk
54
Sets the Layer 2 interface as access.
Sets the Layer 2 interface as trunk.
Sets the layer 2 interface as converged.
switch(conf-if-te-0/19)#switchport mode access
switch(conf-if-te-0/19)#switchport mode trunk
switch(conf-if-te-0/19)#switchport mode converged
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01