Qos Cos - Dell 8 Command Reference Manual

16

qos cos

qos cos
Specifies the interface Class of Service (CoS) value.
Synopsis qos cos value
no qos cos
Operands value
Defaults The default CoS value is 0 (zero).
Command Interface configuration mode
Modes
Description Use this command to specify the interface Default CoS value. When Interface ingress QoS Trust is
in the untrusted mode, then the Interface Default CoS value is applied to all ingress traffic for user
priority mapping. When the interface ingress QoS Trust is in the CoS mode, then the Interface
Default CoS value is applied to all non-priority tagged ingress traffic for user priority mapping. Use
the no qos cos command to return the CoS value to the default.
Usage If the interface is QoS trusted, the CoS value of the interface is used to assign a CoS value to all
Guidelines untagged packets entering the interface.
Examples To set the interface CoS value to 2:
To return the interface CoS value to the default:
See Also show qos, qos map, qos trust
244
Specifies the CoS value. The range of valid values is 0-7.
switch(conf-if-te-0/2)#qos cos 2
switch(conf-if-te-0/2)#no qos cos
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01