Permit (Extended Acls) - Dell 8 Command Reference Manual

10

permit (extended ACLs)

permit (extended ACLs)
Configures a MAC address rule to permit traffic based on the source and destination MAC
addresses.
Synopsis permit {any | host MAC _ACL| MAC_ACL} {any | host MAC _ACL| MAC _ACL} [EtherType | arp |
fcoe | ipv4] [count]
no permit {any | host MAC _ACL| MAC_ACL} {any | host MAC _ACL| MAC _ACL} [EtherType | arp |
fcoe | ipv4]
Operands any
host MAC_ACL
any
host MAC_ACL
arp
fcoe
ipv4
count
Defaults By default, no MAC ACLs are configured.
Command Feature Access Control List Configuration mode
Modes
Description Use this command to configure rules to match and to permit traffic based on the source and
destination MAC addresses, and the protocol type. You can also enable counters for a specific rule.
There are 255 ACL counters supported per port group. Use the no permit command to remove a
rule from the MAC ACL.
Usage The first set of {any | host MAC_ACL | MAC_ACL} parameters is specific to the source MAC
Guidelines address. The second set of {any | host MAC_ACL | MAC_ACL} parameters is specific to the
destination MAC address.
Example To create a rule in a MAC extended ACL to permit IPv4 traffic from the source MAC address
0022.3333.4444
packets:
148
Specifies any source MAC address.
Specifies the source host MAC address for which to set permit conditions.
Use the format HHHH.HHHH.HHHH.
MAC_ACL Specifies the source host MAC address for which to set permit conditions.
Use the format HHHH.HHHH.HHHH.
Specifies any destination MAC address.
Specifies the destination host address for which to set permit conditions. Use
the format HHHH.HHHH.HHHH.
MAC_ACL Specifies the destination host address for which to set permit conditions. Use
the format HHHH.HHHH.HHHH.
Ethertype Specifies the protocol number for which to set the permit conditions. The
range of valid values is 1536-65535.
Specifies to permit the Address Resolution Protocol (0x0806).
Specifies to permit the Fibre Channel over Ethernet Protocol (0x8906).
Specifies to permit the IPv4 protocol (0x0800).
Enables counting of the packets matching the filter rule.
to the destination MAC address
switch(conf-macl-ext)#permit 0022.3333.4444 0022.3333.5555 ipv4 count
and to enable the counting of
0022.3333.5555
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01