Multiplier - Dell 8 Command Reference Manual

multiplier

Sets the number of consecutive misses of hello messages before LLDP declares the neighbor as
dead.
Synopsis multiplier value
no multiplier
Operands value
Defaults The default multiplier value is 4.
Command Protocol LLDP configuration mode
Modes
Description Use this command to set the number of consecutive misses of hello messages before LLDP
declares the neighbor as dead. Use the no multiplier command to return to the default setting.
Usage There are no usage guidelines for this command.
Guidelines
Examples To set the number of consecutive misses:
See Also hello
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
Specifies a multiplier value to use. The range of valid values is 1-10.
switch(conf-lldp)#multiplier 2
6
multiplier
111