Xerox 6030 User Manual page 67

Operation Procedure
1
2
Press the <Sample Copy> key on the control panel.
The [Sample Copy] screen will be displayed.
Ready to Sample Copy.
Sample Copy
To change setup, press [Change Setup].
To change the print image range,
press [Output Range Setting] button.
To cancel sample copy,
press [Sample Copy] button again.
Change
Setup...
Press the [Output Range Setting] button to set up the output range, or the
[Change Setup] button to set up the required functions.
When the [Output Range Setting] button has been pressed
The [sample copy Output Range Setting] screen will be displayed.
Ready to Sample Copy.
Sample Copy
Cancel
Output Range Setting
Start Position
Part Output
Part Output
(0 1200)
(Density)
0
Select either [Part Output] or [Part Output (Density)]. Then, set up the start
position and the measurement value with the use of the [ ] and [ ] buttons.
Press the [+100] or [–100] buttons to change the value in increments of 100.
Output Range
Setting...
Done
Measurement
(50 200)
mm 50 mm
+100
-100
3.4 Sample Copies
39