Xerox 6030 User Manual page 194

Serial
The following communication parameters need to be set up.
Handshake
Communication
Speed
(Baud Rate)
Parity
Data Bit
Stop Bit
EOP Timeout
O u t p u t
Response
Job Separation
166
Chapter 9 Printer Setup
Menu Item
The handshake method is selected from the following choices.
The default setting is [XON/XOFF].
[XON/XOFF] Handshake using the XON/XOFF protocol.
[HARDWARE] Handshake using the hardware.
[ENQ-ACK]
[SOFTWARE] Handshake using the application program.
The communication speed is selected from [300], [1200],
[2400], [4800], [9600] and [19200].
The default setting is [9600].
The parity bit is selected from [NO], [EVEN] and [ODD].
The default setting is [EVEN].
The data bit length is selected from [7_BIT] and [8_BIT].
The default setting is [7_BIT].
The stop bit length is selected from [1_BIT] and [2_BIT].
The default setting is [1_BIT].
The timeout value is entered within a range of 1 to 255 seconds.
The default setting is [10 sec].
Sets the output response to [YES] or [NO].
This must be set [YES] if the printer requires a response when
data is transmitted from the host to the printer.
The default setting is [NO].
Sets the job separation. The default setting is [NO].
[YES]
[NO]
If a value higher than [255] is entered for the timeout value, [255] will be set as the
value.
Description
Handshake using the ENQ-ACK protocol.
Starts conversion processing once the command
that recognizes the end of the data is received
even midway through the file.
Performs the spooling process on the hard disk
until a timeout is issued.