Xerox 6030 User Manual page 200

Serial
PORT SETTING
SERIAL
SERIAL
Baud Rate
Baud Rate
300
Centronics (optional)
PORT SETTING
CENTRO
CENTRO
DMA Timeout
DMA Timeout
005 sec
172
Chapter 9 Printer Setup
1
2
3
*
1
2
3
*
Display [SERIAL] on the setup item selection
screen, and then press the <
Select the item that is to be set up with the use of
the < > and < > keys, and then press the
< > key.
[Handshake], [Baud Rate], [Parity], [Data Bit],
[Stop Bit], [EOP Timeout], [Output Response],
and [Job Separation] will be displayed in this
order.
Select the parameters with the use of the < >
and < > keys, and then press the <Set> key.
An [*] mark will be displayed on the right-hand
side of the parameters once they have been set.
Display [CENTRO] on the setup item selection
screen, and then press the <
Select the item that is to be set up with the use of
the < > and < > keys, and then press the
< > key.
[Ack Mode], [DMA Timeout], [EOP Timeout],
and [Job Separation] will be displayed in this
order.
Select the parameters with the use of the < >
and < > keys, and then press the <Set> key.
An [*] mark will be displayed on the right-hand
side of the parameters once they have been set.
> key.
> key.