Xerox 6030 User Manual page 235

IOT Status Details
The following details are displayed for the IOT status.
IOT_READY/
IOT_IDLE
IOT_RUN
IOT WARMUP
IOT_OFFLINE
IOT_COPY_MODE
IOT_POWER_SAVE
IOT_MC_ERR
IOT_JAM_ERR
IOT_SET_ERR
IOT_TONER_ERR
IOT_DOOR_ERR
IOT_COM_ERR
IOT_NO_PAPER
IOT_UNKWN_ERR
Displayed Item
The printer is on standby.
The printer is printing.
The printer is warming up.
The printer is in the offline status. Check the printer control
panel to discover the cause.
The printer is in the copy mode.
The printer is in the sleep mode.
Press the <
panel simultaneously. If the problem is not recovered,
contact your Xerox Service Representative.
Paper is jammed in the printer. Remove the jammed paper.
An error that could have arisen from the power of the post-
processing unit not being switched on or another problem
has occurred. Check the post-processing unit.
The printer's toner has run out.
The printer's door is open. Close the door.
A communication error has occurred with the printer.
Switch off the power of the printer, and then switch it on
again. If the problem is not recovered, contact your Xerox
Service Representative.
The printer's paper has run out. Place more paper in the
tray that is empty.
An error that cannot be recovered has occurred with the
printer. Switch off the power of the printer, and then switch
it on again. If the problem is not recovered, contact your
Xerox Service Representative.
Description
> and < > keys on the printer control
10.3 Printer Operations
207