Xerox 6030 User Manual page 419

Command name
Assign Color Index
Number
Push/Pop Palette
Start Raster Graphics ESC * r # a|A
End Raster Graphics
Transfer Raster Data
by Plane
Transfer Raster Data
by Row/Block
Set Compression
Method
Source Raster Width
Source Raster Height ESC * r # t|T
Move CAP
Horizontal
(Decipoint)
Move CAP
Horizontal
Move CAP Vertical
Y Offset
Destination Raster
Width
Destination Raster
Height
Command Command Meaning and function
ESC * v # i|I Assigns a defined RGB parameter to an
index number.
ESC * p # P Saves and restores palette information.
Sets the controller to the raster mode and
sets the start position and left margin of a
graphic image.
ESC * r C Indicates the end of raster graphic image
transfer.
ESC * b # Transfer's the data of a specified byte.
V[data] However, the CAP does not move to the
next raster position.
The plane pointer is updated but the row
pointer is not.
ESC * b # Transfer's the data of a specified byte as a
W[data] line or as a block by the current
compression method.
ESC * b # m|M Determines the compression method.
ESC * r # s|S Indicates the image width of succeeding
raster data.
Indicates the source raster image height of
succeeding raster data.
ESC & a # h|H Moves the CAP horizontally by a specified
decipoint (1/720 inch).
ESC * p # x|X Moves the CAP horizontally by a specified
value in Versatec resolution inch units.
ESC * p # y|Y Moves the CAP vertically by a specified
value in Versatec resolution inch units.
ESC * b # y|Y Moves the CAP vertically by specified
pixel rows.
ESC * t # h|H Defines the raster output width for
succeeding Start Graphic command by
decipoint (1/720 inch).
ESC * t # v|V Defines the raster output height for
succeeding Start Graphic command by
decipoint (1/720 inch).
Appendix 3 HP-RTL Command List
Limit
Index Number
Ignored
Data skipped
391