Moog Curlin 6000 CMS IOD User Manual page 134

At the following screens, the dose information is entered to complete the programming of the
pump for a Variable
Note: One dose per screen is entered.
1. DOSE: e dose number on the rst eld changes to indicate which dose is currently being
programmed. e total number of doses is also displayed, and the pump will only prompt
programming screens for the number of doses indicated on the initial programming screen.
2. Amt TBI: Use the numeric keys to enter the amount to be delivered in this dose.
selected in the prescription menu will automatically appear in this eld, whether mL, mg, or
mcg. e amount to be infused is limited to the bag volume total, and each time a dose is
programmed, the new amount to be infused is limited to the remaining bag volume total. When
the amount is correctly entered, press the YES/ENTER key to accept, and move to the next eld.
e range for this eld is 1 to 9999, or the remaining bag volume amount.
3. RATE: e Moog Curlin Infusion pump can deliver from 0.1 mL to 400 mL per hour. Use
the numeric keys to enter the prescribed rate for this dose. When this eld is correct, press the
YES/ENTER key to accept, and move to the next eld.
4. TIME (calculated by pump): Displays the time required to complete this dose. If the time is
not acceptable, press the NO key to edit this eld, and enter the new TIME. (Remember, when
you change the time, a new RATE will be calculated and will have to be accepted before you exit
this menu.) When the time is correct, press YES/ENTER to accept, and move to the next eld.
e range for this eld is 0:01 to 288:00 HH:MM.
Note: e time entered is limited by what time is remaining out of the maximum time of 288
hours. e time calculated by the pump may be less than a minute, however, one minute is
the minimum entry and display value.
erapy. Each variable dose will have its own prescription screen:
V a r i a b l e P r e s c r i p t i o n
V a r i a b l e P r e s c r i p t i o n
1 2 2
M e n u 2
M e n u 3
e units