The Tools Submenu; Timer Operation; Interval Timer Operation; Stopwatch Timer Operation - Labconco Logic Vue User Manual

The Tools Submenu

This submenu is reserved for use by certifiers, during certification or service
procedures. CAUTION! - Entering this submenu will disable some alarms and
functionality so that diagnostic and certification procedures can be performed.
Additional details on the Tools Submenu are found in
8: Calibration, and

Timer Operation

The timer allows activation of an interval (countdown) or elapsed (stopwatch) timer. The
timers cannot be operated simultaneously.
To access the Timer Menu, press
Home Screen). The Timer Menu is displayed (Figure 6-17). Select
Timer, then [OK/MUTE].
Stopwatch

Interval Timer Operation

1. The interval timer defaults to 05:00 (minutes:seconds).
2. Press [UP] or
3. When the proper interval is selected, press
4. When the timer reaches 00:00, an audible alarm will sound.
5. Press [OK/Mute]
timer will reset to the previously selected interval.
6. Press [Menu]

Stopwatch Timer Operation

1. The stopwatch timer defaults to 00:00.
2. Press [OK/Mute]
3. Press [OK/Mute]
the timer will reset to 00:00.
4. Press [Menu]
Section 9: Diagnostics.
[Timer]
Figure 6-17
[DOWN] to increase or decrease the timer interval.
to pause the timer. Press
to clear the interval timer and return to the main timer menu.
to start the timer.
again to pause the timer. Press
to return to the main timer menu.
Section 7:
anytime during normal operation (from the
[OK/Mute]
[OK/Mute]
[OK/Mute]
79
Configuration, Section
Interval or Stopwatch
Interval
to start the timer.
while paused, and the
while paused, and