Labconco Logic Vue User Manual page 92

To access the Filter Life Gauge screen(s), follow the steps in
Speed previously shown in this section, until on the
these instructions:
1. On the Supply Blower Speed
SUPPLY
CURRENT RPM = 1217
AVERAGE RPM = 1219
'OK' TO CONTINUE
'OK' displayed when blower speed stabilizes
2. Use [UP] or [DOWN]
press [OK/MUTE].
3. On the Exhaust Blower Speed
EXHAUST
CURRENT RPM = 1193
AVERAGE RPM = 1075
'OK' TO CONTINUE
'OK' displayed when blower speed stabilizes
4. Use [UP] or [DOWN]
press [OK/MUTE].
Note: Each filter has a separate Life Gauge for percentage of filter remaining. The
lower of the two Filter Life percentages is displayed on the Home Screen.
screen, press [OK/MUTE].
58
[OK/MUTE]
to select one of the three Filter Life options displayed,
screen, press [OK/MUTE].
51
[OK/MUTE]
to select one of the three Filter Life options displayed,
Adjusting the Blower
Blower Speed
NEW FILTER
SAME FILTER
SET FILTER LIFE
NEW FILTER
SAME FILTER
SET FILTER LIFE
92
screen. Then follow
SUPPLY
EXHAUST