ETC Obsession User Manual page 41

Chapter 2 Monitor displays 41
View Channels
Press [S4], View Channels, to make a range of channels visible.
If Show Channels or Current Channels are active, View Channels
selects only channels that are already visible in the current Flexi-
channel mode.
The spreadsheet below displays all channels 1 through 5 and 21
through 25. The View Channels option allows you to compare two
sets of channels side by side that might normally not appear on
the same screen. Note that a grey appears between the two
sets of channels. This indicates channels that have levels but
aren't being shown.
Note: View Channels may also be used when Flexichannel is off
(All Channels sele ted).
Note: As wel as entering ranges of channels to view, such as
[View Channe s] [1] [Thru] [5][0] [Enter], you may enter commands
like [View channels] [Group] [1] [Enter] to view only the channels
in group 1 o [View Channels] [Group] [Cue] [6] to view the chan-
nels in ue 6.