ETC Obsession User Manual page 292

292
Configuring MIDI Show Control (MSC)
Each device receiving MIDI Show Control information must be
assigned a device ID. Obsession can receive MSC information,
transmit MSC information, or both.
You may enable input and/or output of MSC and assign MSC
device IDs for incoming and outgoing data.
1. Press [Setup*] to go to the Setup Menu.
2. Press [2] [Enter] to select the I/O Configuration Menu.
3. Press [4] [Enter] to select the MIDI Show Control Menu. The
following display appears:
4. To allow your ons le to receive MIDI signals from another
MIDI devic
Control Inpu
5. If input is enabled, the console's Obsession Device ID must
match the target device ID for the MIDI device from which
yo want to receive signals. Press [2] [Enter] and enter an ID
(1-126).
6. To allow another MIDI device to receive MIDI signal from your
console, press [3] [Enter] [Enter] to enable MIDI Show Con-
trol Output.
7. If output is enabled, the Target Device ID must match the de-
vice ID for the MIDI device to which you want to send signals.
Press [4] [Enter] and enter an ID (0-126).
pre s [1] [Enter] [Enter] to enable MIDI Show
Obsession User Manual