ETC Obsession User Manual page 277

Chapter 22 Sensor dimming
Enabling dimmer monitoring
Once the ETCLink address is set, you can enable dimmer
monitoring.
Keystrokes:
1. Press [Setup*].
2. Press [2], Input/Output
Configuration, [Enter].
3. Press [1], I/O Options,
[Enter].
4. Press [2], Dimmer Moni-
toring, [Enter].
5. Press [Enter] to enable
dimmer monitoring, or
press [Clear] to cancel.
Storing ETCLink configuration
Your ETCLink configuration rem ins n yo r system's memory
until it is replaced, or you reset the system. You may back up
configuration information on a d sket
228 or 237 for instructions
Action/Command line:
Selects I/O Configuration menu
Selects I/O Options menu
ENABLE DIMMER
MONITORING?
Dimmer Monitoring is en bled
or the hard drive. See page
277