ETC Obsession User Manual page 150

150
Submaster types
Submasters can be additive or inhibitive. A green submaster
bump button LED indicates an additive submaster, red indicates
an inhibitive submaster.
Additive submasters
An additive submaster contains a set of channels, recorded at
proportional levels. Additive submasters interact with established
channel levels on a highest level basis. The home position for an
additive submaster's slider is zero.
Inhibitive submasters
An inhibitive submaster contains channels whose output is held
below a specified level. An inhibitive submaster doesn t act ally
set channel levels, it prevents channel outputs from exceeding a
specified level. The home position for an inhibitive submaster's
slider is Full.
Changing type
When you change a submaster from one ype to the other, the
change does not become effective until you move its slider to the
home position for its old type, then
new type. Changing type does n t ffect levels recorded in a
submaster.
Keystrokes:
1. Press [Sub*]
2. Press [Sub] [#].
3. Press [S1], Sub Type, [Enter]. Sub: SUB 1 ADDITIVE or
Obsession User Manual
the home position for its
Action/Command line:
Sub: SUB 1
Sub: SUB 1 INHIBITIVE