ETC Obsession User Manual page 347

Appendix C Error messages
Maximum command line length exceeded
A command line may be up to 200 commands or 1,024 characters
long, whichever comes first.
Must be the active cue
You may not update any cue other than the active cue. In Live
mode, a selective record or a record to a multipart must be to the
active cue.
Not valid in current configuration
You may not change the beginning number of a DMX512 port if
the port is multiplexed.
Parts cannot be combined in list
You may not use specific parts of a multipart cue in a list using
[Thru], [+] or [–]. Only whole cues (including multipart cues) may
be included.
Resulting elements list is too long
When Obsession generates element lists using a one-to-one
channel assignment, the element lists created may ot use more
than 42 characters each.
Show not found
When you select a show from the hard d k by name, be certain
the name you enter matches the how's name exactly. Check
upper and lower case letters and ma e sure they are correct.
Stage levels may change - Please co firm
When you update a submas er, set the submaster's slider to 10
to avoid possibly cha ging levels on the stage. If an output's level
is higher than the curr nt level of the slider, Obsession lowers the
output level to matc the slider. This allows the submaster to
recreate the leve on the stage at the time of the update any time
the submaste slider is returned to its setting at the time of the
update.
Step time ust be in seconds or tenths
You m y not set step times in hundredths of a second.
Too many cues/parts to put on wheel
The channel you have selected appears in more than 1,536 cues
and parts. The wheel can control a maximum of 1,536 elements.
347