ETC Obsession User Manual page 196

196
Linking macros
Any macro may end with a link to another macro. When the first
macro runs, the second macro automatically follows. Press the
appropriate macro key at the end of your sequence to create the
link. This automatically ends and stores the macro.
This example creates a macro that sets all active channels to 50
percent, fades them out, then runs another macro.
Keystrokes:
1. Press [Setup*] [1][0]
[Enter].
2. Press [Macro] [1] [Enter].
3. Press [Enter] [At] [5][0]
[Enter].
4. Press [Sneak] [Time] [1][0]
[Enter].
5. Press [M3].
Note: You may also link a ma ro to a cue. See page 97.
Obsession User Manual
Action/Command line:
Selects Macro editing mode
Selects macro 1 to create
MACRO 1
Sets all active channels to 50
percent
Macro line reads: @ 50
Sneaks all active channels out in
ten seconds.
Macro line reads:
@ 50 SNEAK TIME 10
Stores mac o Links macro to
mac o 3
Macro line reads:
@ 50 SNEAK TIME 10 M3