ETC Obsession User Manual page 258

258
Storing Multiuser configuration
Your Multiuser configuration remains in your system's memory
until it is replaced, or you reset the system. You may back up
configuration information on a diskette or the hard drive. See page
228 or 237 for instructions.
Mirror
In Multiuser mode, the [Mirror] key (located between [Memo] and
[Expand] on Remote Consoles and Designer's Remote Consoles)
lets you monitor the actions of the other User. As soon as you use
a slider, run a cue or generate a command line instruction, your
displays return to normal.
Note: The Mirror function is not available from the system's m in
console (or backup console, if you are using Full Tracking Backup)
Enable/Disable Multiuser devices
You may disable any device on the network from any Full Console,
Remote Console or Designer's Remote Conso e T e device
stays disabled until it is either enabled from a console, or turned
off and on. At least one console must remai enabled.
Keystrokes:
1. Press [Setup*].
2. Press [2], Input/Output
Configuration, [Enter]
3. Press [2], Multiuser
Configuration, Ente .
4. Press [S1], Dev ce
Number and enter the
device.
5. Pre s [S4], Enable/
Disable.
6 Press [Enter] to confirm
the assignment.
Obsession User Manual
Action/Command line:
Selects Input/Output
Configuration menu
Selects Multiuser
Configuration display
I/O Devices:
DEVICE NUMBER 2
I/O Devices: DEVICE
NUMBER 2 ENABLE /
DISABLE
Device is disabled
I/O Devices: DEVICE
NUMBER 2 ENABLE /
DISABLE