ETC Obsession User Manual page 187

Chapter 12 Effects
Loading an effect to a submaster
An effect played back from within a submaster interacts with
cues and other submasters on a highest level basis.
An effect loaded to a submaster fades proportionally between
zero and the effect's high level. The slider acts as a master. If the
effect's low level is normally 10 percent, moving the slider to 50
percent will reduce the effect's low level to 5 percent.
Note: If you load an effect to a submaster, and then change the
effect, the new version of the effect is automatically loaded to the
submaster when you leave effect mode or select a different
effect to edit.
These steps load effect 1 to submaster 2.
Keystrokes:
1. Create an effect.
2. Press [Live*].
3. Press [Load Sub] [2].
4. Press [Effect] [1].
5. Press [Enter].
Note: Due to limited memory, you may not be able to load all your
effects to submasters.
Note: Channel levels are not affected by an effect until a step runs
that specifically addresses the channel.
Action/Command line:
Live: LOAD SUB 2
Live: LOAD SUB 2 EFFECT 1
Live: LOAD SUB 2 EFFECT 1
187