Recording Vaxstation 3100 System Information; Shut Down The Software; Enter The Show Device Command - Digital Equipment VAXstation 3100 Series Upgrade Manual

Recording VAXstation 3100 System Information

Recording VAXstation 3100 System Information
Refer to the VMS Installation and Operations Manual for the
Shut Down the
proper operating system shutdown procedure.
Software
Before you begin the upgrade you need to record the system
Enter the
Ethernet address (only if you are moving the Ethernet ROM to
SHOW DEVICE
the new system) and the SCSI ID settings on your disk drives.
Command
Follow these steps and refer to Figure 1–1:
1. Press the Halt button on the rear of the system unit.
2. Enter the SHOW DEVICE command at the console prompt
3. Record the system Ethernet address (if applicable).
4. Record the SCSI ID number for each drive.
1–4 Preparing for the System Upgrade
Result: The system displays the console prompt (>>>) on the
screen.
and press .
Return