Troubleshooting and Maintenance
Manual Dialing Out When an Alarm Occurs
Displaying Directory Numbers
5-4
6. Press Ctrl-a to switch to the screen function key area.
7. To save changes, select Save and press Return. The Save Configuration To
screen appears.
8. Select the configuration area where you want to save the changes to and
press Return. When Save is complete, Command Complete appears at the
bottom of the screen.
Configure the external device connected the the access unit's COM port. Then,
use the COM Port Call Setup screen to:
Select the desired telephone number.
Dial a call.
Disconnect a call.
Procedure
1. Follow this menu selection sequence:
Main Menu
Control
2. Enter the desired directory number, or press the spacebar to cycle through
the numbers that have been set up in the directory. The telephone number
appears in the Directory Phone Number field.
See
Displaying Directory Numbers and Changing Directory Numbers
information about the call directory.
3. Select Dial and press the Enter key to initiate dialing.
4. To end the call, select Disconnect and press the Enter key.
Use the COM Port Call Setup screen to display the telephone number of the
remote device.
Main Menu
Control
September 1997
COM Port Call Setup
COM Port Call Setup
for
9161-A2-GH30-20