Logging Out; Starting A Session - Paradyne 9161 User Manual

Start-Up

Logging Out

Starting a Session

3-2
When a login is required and a timeout occurs, you are automatically logged out.
You will be prompted for your login next time you try to use the interface.
You can also end a session using the screen function area of the user interface.
Procedure
To log out:
1. Press Ctrl-a to switch from the screen area to the screen function key area.
2. Select Exit by entering e or E and pressing Return. The session is ended.
Depending on how your T1 access unit is configured, you can start a session
using one of the following methods:
Dialing in through an external modem to the COM port.
Direct connection over the COM port.
Telnet session over the COM port.
Telnet session through an in-band management channel through the T1
network.
Procedure
Upon beginning a session, the user interface is blank. To activate:
1. Press Return.
2. One of the following occurs:
If . . .
Security is disabled
Security is enabled
You are attempting to
access through Telnet and
the user interface is
currently in session
November 1996
Then . . .
The Main Menu screen
appears.
You are prompted for a
login ID and password.
The message Connection
refused: appears. (T1
access unit allows only
one connection at a time.)
What to do now?
Begin your session.
Enter your ID and
password. If Invalid
Password appears, see
System Error Messages in
Chapter 5.
See System Status
Messages
in Chapter 5.
9161-A2-GB20-00