Configuring Snmp Traps; Dialing Out Snmp Traps - Paradyne 7110 User Manual

Configuring SNMP Traps

Dialing Out SNMP Traps

7110-A2-GB20-00
An SNMP trap can be automatically sent out through the FDL or the Management
port to the SNMP manager when the DSU/CSU detects conditions set by the
user. These traps enable the SNMP manager to gauge the state of the network.
Refer to Standards Compliance for SNMP
SNMP traps supported by the DSU/CSU.
To configure the DSU/CSU for SNMP traps, use the SNMP Traps Options screen
to:
Enable SNMP traps.
Set the number of SNMP managers that receive SNMP traps from the
DSU/CSU.
Enter an IP address and network destination for each SNMP manager
specified.
Select the type of SNMP traps to be sent from the DSU/CSU.
To configure SNMP Traps, follow this menu selection sequence:
Main Menu Configuration
SNMP & Communications
Refer to SNMP Traps Options, Table A-13.
Configure the SNMP traps before performing this procedure.
Procedure
1. Configure the phone directories to use when dialing out SNMP traps through
the Management port and a connected external device. Refer to the
Setup section in Chapter 3.
2. Use the Alarms & Traps Options to enable the DSU/CSU's automatic call
initiation to a remote device with Alarm & Trap Dial-Out, Call Retry, and
Alternate Dial-Out Directory. Follow this menu selection sequence:
Main Menu Configuration
Alarms & Traps
Refer to Alarms & Traps
June 1997
Traps, Appendix D, for details of
Load Configuration From
SNMP Traps
Load Configuration From
Options, Table A-9.
Messages and Troubleshooting
Call
6-3