Paradyne 7110 User Manual page 70

7110-A2-GB20-00
When user access to the ATI is attempted through the Terminal port or a Telnet
session, the ATI response is based on the Login Required option and the
availability of the ATI. Table 7-2 describes how the system responds to various
ATI access conditions.
Table 7-2. ATI Access Conditions
If access to the ATI
Then . . .
is through the . . .
Terminal port with The Main Menu screen
Security disabled with appears.
the Login Required
option set to Disable
(See Table A-5)
Terminal port with You are prompted for a
Security enabled with login ID and password.
the Login Required
option set to Enable
(See Table A 5) (See Table A-5)
The Main Menu screen
appears if the login ID is
not configured yet.
Terminal port and the User Interface Already
ATI is already in use In Use message appears
with a Telnet session with the active user's IP
address and Login ID.
Telnet session and the Connection Failed
ATI is currently in use message appears. The
DSU/CSU allows only
one connection or active
interface at a time.
June 1997
What to do now?
Select a menu option to begin your
session.
If Invalid Password appears,
re-enter the password. After three
tries with an invalid password,
contact the system administrator.
Select a menu option to begin your
session.
Try again later. When the ATI is
available, the message User
Interface Idle appears.
Try again later.
Security
7-5