Call Setup; Call Setup Screen - Paradyne 7110 User Manual

Customizing the DSU/CSU

Call Setup

Call Setup Screen

3-8
From the Control menu, the Call Setup screen is available for the Management
port when connected to an external device, such as a modem or an X.25 PAD.
Use the Call Setup screen to:
Dial or disconnect an active call with an external device. The External Device
Commands option must be set to AT or Other (not to Disable). Refer to
External Device Options, Table A-7.
Display or change the phone numbers that are used to:
— Send an ASCII alarm message to an ASCII terminal or printer.
— Send an SNMP trap message.
To access the Call Setup screen, follow this menu selection sequence:
Main Menu Control
main/control/phone
Device Name:
1:xxxxxxx
2:xxxxxxx
3:xxxxxxx
4:
5:
Alarm:
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Ctrl-a to access these functions, ESC for previous menu
Save
Select: 1, 2, 3, 4, 5, A
The Phone Number fields allow 40 characters. For valid
refer to Table 3-1.
After entering or changing a phone number, press Ctrl-a to go to the function key
area below the dotted line. Select Save and press Return.
After completing call setup, the Management port can be used to send out ASCII
alarms and SNMP traps. The Alarm & Trap Dial-Out option must be enabled.
Refer to Alarms & Traps
June 1997
Phone Call & Directory
PHONE CALL AND DIRECTORY
Phone Number: 1
Dial
Disconnect
Options, Table A-9.
Model: 7110
Clear
Clear
Clear
Clear
Clear
Clear
MainMenu Exit
Phone Number entries,
7110-A2-GB20-00