Remote Send Line Loopback - Paradyne 7110 User Manual

Testing

Remote Send Line Loopback

5-6
Remote Send Line Loopback sends the line loopback up or down code on the
network interface for 10 seconds.
Procedure
To run a Send Remote Line loopback:
1. Position the cursor at the Up or Down selection next to Send Line Loopback
on the Network Tests screen.
2. Press the space bar to select either Up or Down.
3. Position the cursor at the Send command next to Up or Down selection.
4. Press Enter.
5. The Send command is changed to Sending. The loopback will stop
automatically after 10 seconds. You cannot stop the test manually.
Remote Send Line Loopback cannot be started when any other loopback or a
Send Pattern test is already active on the network interface.
June 1997 7110-A2-GB20-00