Paradyne 7110 User Manual page 98

7110-A2-GB20-00
Table A-10. Communication Protocol Options (2 of 3)
Default Network Destination
Possible Settings: None, Mgmt, FDL
Default Setting: None
Specifies where the default network is connected. The routing protocol uses this option
to route data with no specific route.
WARNING: Unroutable data is discarded if the Default Network Destination
becomes disabled or the option is set to None. Change the default
network destination if the default route is not operational.
None – No default network destination; unroutable data is discarded.
Mgmt – The Management port is the default network destination.
Port Use option must be set to Net Link in Table A-6.
FDL – The Facility Data Link management channel is the default network destination.
Management Port IP Address
Possible Settings: 000.000.000.000 – 223.255.255.255, Clear
Default Setting: 000.000.000.000
Specifies the Internet Protocol address for the Management port.
Port Use option must be set to Net Link in Table A-6 for the Management Port IP
Address to be effective.
000.000.000.000 – 223.255.255.255 – Sets the Management port IP address. The
range for the first byte is 000 to 223, with the exception of 127. The range for the
remaining three bytes is 000 to 255.
Clear – Clears the IP address and sets to all zeros.
NOTE: This IP address is also used if the Alternate Directory Phone Number is
attempted and the Alternate Mgmt Port IP Address option is all zeros.
Management Port Subnet Mask
Possible Settings: 000.000.000.000 – 255.255.255.255, Clear
Default Setting: 000.000.000.000
Specifies the subnet mask needed to access the Management port.
000.000.000.000 – 255.255.255.255 – Set the Management port subnet mask. The
range for each byte is 000 to 255.
Clear – Clears the subnet mask and sets to all zeros. When the subnet mask is all
zeros, the device creates a default subnet mask based on the class of IP address:
– Class A defaults to 255.000.000.000
– Class B defaults to 255.255.000.000
– Class C defaults to 255.255.255.000
Management Port Link Protocol
Possible Settings: PPP, SLIP
Default Setting: PPP
Specifies the link layer protocol for the Management port.
Port Use option must be set to Net Link in Table A-6 for the Management Port Link
Protocol to be effective.
PPP – Point-to-Point Protocol.
SLIP – Serial Line Internet Protocol.
Port Type option must be set to Asynchronous in Table A-6.
June 1997
Configuration Option Tables
A-23