Paradyne 7110 User Manual page 131

MIB Descriptions
C-20
Table C-7. DS1 Near End Group Configuration Table Objects (5 of 5)
Object, OID, Access
dsx1TransmitClock–
Source
(dsx1ConfigEntry 12 )
1.3.6.1.2.1.1.10.18.6.1.12
read-only
dsx1Fdl
(dsx1ConfigEntry 13 )
1.3.6.1.2.1.1.10.18.6.1.13
read-write
June 1997
Description
This object specifies the
timing source for the
transmit clock for this T1
interface. This object differs
from the MIB definition in
that it is "read-only" (not
read/write) for DSU/CSUs.
This object specifies how
Facility Data Link is being
used.
Setting/Contents
Supports the following
values:
loopTiming(1) – The
recovered receive clock is
being used as the transmit
clock.
localTiming(2) – The
DSU/CSU's internal clock
is used being as the
transmit clock.
ThroughTiming(3) – The
recovered receive clock
from another interface
(e.g., network or
synchronous data port) is
being used as the transmit
clock.
More than one value may be
active at a time.
Supports the following
values:
dsx1other(1) – SNMP
data is being sent over
FDL.
dsx1Ansi-T1-403(2) –
ANSI PRMs are supported
on the network interface as
specified by ANSI T1.403.
dsx1Att-54016(4) – FDL
supports the requirements
specified by AT&T
publication TR54016.
dsx1Fdl-none(8) –
Indicates that the device
does not use FDL.
7110-A2-GB20-00