Test Patterns For The Dte - Paradyne 7110 User Manual

Test Patterns for the DTE

7110-A2-GB20-00
This test sends a QRSS or 511 test pattern, or monitors a QRSS or 511 test
pattern over the User Data Port interface.
Procedure
To run a Send Pattern test:
1. Position the cursor at the QRSS or 511 pattern selection next to Start QRSS
on the Sync Data Port Tests screen.
2. Press the space bar to select the desired test pattern (QRSS or 511).
3. Position the cursor at the Start command next to the desired Send pattern.
4. Press Enter.
5. The Start command is changed to Stop. If you want to manually stop the test,
verify that the cursor is positioned at the Stop command.
Procedure
To run a Monitor QRSS Pattern test:
1. Position the cursor at the Start command next to Monitor QRSS on the Sync
Data Port Tests screen.
2. Press Enter.
3. The Start command is changed to Stop. If you want to manually stop the test,
verify that the cursor is positioned at the Stop command.
The Send and Monitor Pattern tests cannot be started when any loopback is
already active on the data port.
June 1997
Testing
5-13