Synchronous Port Table Objects - Paradyne 7110 User Manual

Synchronous Port Table Objects

The Synchronous Port Table Objects contains an entry for the synchronous user
data port and the Management port when this port is configured for synchronous
operation. For this unit, entries in the table that are counters (rs232SyncPortEntry
3–7) are used to collect statistics only and are not supported. Clarification for
objects contained in this table as it applies to the unit is provided below.
7110-A2-GB20-00
Table C-13. Synchronous Port Table Objects (1 of 2)
Object, OID, Access
rs232SyncPortClock-
Source
(rs232SyncPortEntry 2 )
1.3.6.1.2.1.10.33.4.1.2
read-write
rs232SyncPortRole
(rs232SyncPortEntry 8 )
1.3.6.1.2.1.10.33.4.1.8
read-write
rs232SyncPortEncoding
(rs232SyncPortEntry 9 )
1.3.6.1.2.1.10.33.4.1.9
read-write
rs232SyncPortRTS-
Control
(rs232SyncPortEntry 10 )
1.3.6.1.2.1.10.33.4.1.10
read-write
rs232SyncPortRTSCTS-
Delay
(rs232SyncPortEntry 11 )
1.3.6.1.2.1.10.33.4.1.11
read-write
June 1997
Description
Specifies the clock source
for the port.
Specifies whether this
device interface is a DTE or
DCE.
Specifies the bit encoding
technique that this port
uses.
Specifies the method used
to control the RTS signal.
Reports the interval (in
milliseconds) that the port
waits after RTS is asserted
before asserting CTS.
MIB Descriptions
Setting/Contents
Supports only the following
values:
internal(1) – The port uses an
internal clock.
external(2) – The port uses an
external clock.
Supports only the following
value:
dce(2) – The port acts as a
DCE.
Supports only the following
value:
nrz(1) – The port uses
non-return to zero encoding.
nrzi(2) – The port uses
non-return to zero-inverted
encoding. This corresponds to
the inverted transmit and
receive data relationship.
Supports only the following
values:
controlled(1) – For User Data
port, this value is used when
the Data Port option Carrier
Control by RTS is set to
Switched.
constant(2) – For User Data
port, this value is used when
the Data Port option Carrier
Control by RTS is set to
Constant. This is the only valid
value for the Management
port.
Supports only the following
read-only values:
0 – The port does not have to
wait. Only valid for
Management port.
C-27