Interface Stack Group; Interface Test Table; Generic Receive Address Table - Paradyne 7110 User Manual

MIB Descriptions

Interface Stack Group

Interface Test Table

Generic Receive Address Table

C-10
The Interface Stack Group is used by the unit to show the relationship between a
logical interface and a physical interface. The following table provides clarification
for objects contained in the Interface Stack group when it is not clear how the
object definition in RFC 1573 is supported by the unit.
Table C-4. Interface Stack Group Objects
Object, OID, Access Description
ifStackHigherLayer Provides the index that
(ifStackEntry1)
corresponds to the higher
sublevel specified by
1.3.6.1.2.1.31.1.2.1.1
ifStackLowerLayer.
read-only
ifStackLowerLayer Provides the index that
(ifStackEntry2) corresponds to the lower
sublevel specified by
1.3.6.1.2.1.31.1.2.1.2
ifStackHigherLayer.
read-only
ifStackStatus Specifies the stack group's
(ifStackEntry3) status compared to the
interface's ifOperStatus.
1.3.6.1.2.1.31.1.2.1.3
read-only
Not supported by the unit.
Not supported by the unit.
June 1997
Setting/Contents
When the FDL in-band
management channel is enabled,
this object for the network T1
interface is set to the ifIndex of
the FDL. All other
ifStackHigherLayer objects will
have a value of zero.
When the FDL in-band
management channel is enabled,
this object (for the FDL) is set to
the ifIndex of the network T1
interface. All other
ifStackLowerLayer objects will
have a value of zero.
When ifStackStatus set to
active – maps to ifOperStatus
set to up(1) or testing(3).
When ifStackStatus set to not
in service – maps to
ifOperStatus set to down(2).
7110-A2-GB20-00